Fletchercash9628

A method for expanding the measurement range of low-coherence digital holography up to several times longer than the coherence length is proposed. The method was implemented with a multireflection reference mirror composed of partially and highly reflective mirrors, in conjunction with the Fourier transform method with spatial filtering for single-shot complex amplitude imaging, making it useful for observing a moving and deforming object. One of the features of the reference arm is that the measurement range is simply controlled by adjusting the position and angle of the highly reflective mirror. The measurement of objects with a general curved shape and a large step height was demonstrated.A stable, 22.9 W, 671 nm single-frequency laser using a type II noncritically phase-matched external-cavity frequency doubling is demonstrated. The output power of the fundamental laser is 32.1 W; the corresponding conversion efficiency of frequency doubling from 1342 to 671 nm is calculated to be 71.3%. The M2 factors are measured to be 1.10 and 1.08 in the x and y directions, respectively. To the best of our knowledge, 22.9 W is the highest power obtained for a 671 nm single-frequency laser.We report a new polymer/colloidal-quantum-dot (CQD) film with a nanostructured interface, which is fabricated through a template-assisted photopolymerization method, toward the use of amplified spontaneous emission. It is experimentally demonstrated that the amplified spontaneous emission of CQDs is able to be manipulated by changing the nanostructured polymeric interface with a weak scattering ability. The dependences of emission wavelength and threshold on the size of the nanostructure and CQD layer thickness are investigated.We experimentally demonstrate the use of orbital angular momentum (OAM) modes as a degree of freedom to facilitate the networking functions of carrying header information and orthogonal channel coding. First, for carrying channel header information, we transmit a 10 Gb/s on-off keying (OOK) data channel as a Gaussian beam and add to it a 10 Mb/s OOK header carried by an OAM beam with the mode order ℓ=3. We recover the header and use it to drive a switch and select the output port. Secondly, for orthogonal channel coding, we configure transmitters to generate orthogonal spatial codes (orthogonal spatial beam profiles of OAM modes), each carrying an independent data stream. We measure the correlation between the OAM codes and demonstrate their use in a multiple access system carrying two 10 Gb/s OOK data channels. At the end of this Letter, we combine the concepts of using OAM modes for carrying channel header information and orthogonal channel coding in one experiment. We transmit a 10 Gb/s OOK data channel as a Gaussian beam and add to it two 10 Mb/s OOK header waveforms carried by different OAM codes. In the routing node, we recover one of the headers to drive the switch.In this Letter, we experimentally demonstrate low noise 300 GHz wave generation based on a Kerr microresonator frequency comb operating in the soliton regime. The spectral purity of a 10 GHz GPS-disciplined dielectric resonant oscillator is transferred to the 300 GHz repetition rate frequency of the soliton comb through an optoelectronic phase-locked loop. Two adjacent comb lines beat on a uni-traveling carrier photodiode emitting the 300 GHz millimeter-wave signal into a waveguide. In an out-of-loop measurement, we measure the 300 GHz power spectral density of phase noise to be -88dBc/Hz, -105dBc/Hz at 10 kHz, and 1 MHz Fourier frequency, respectively. Phase-locking error instability reaches 2×10-15 at 1 s averaging time. Such a system provides a promising path to the realization of compact, low power consumption millimeter-wave oscillators with low noise performance for out-of-the-laboratory applications.Conventional coherent diffraction imaging (CDI) suffers from inherent phase retrieval ambiguity due to limited intensity-only measurements. Coded illumination with multiple modulations has been introduced to tackle the underdetermination challenge, which however slows down imaging speed. In addition, the required high-dynamic-range acquisition at the Fourier plane is also time consuming. To increase imaging speed, we report an accelerated coded CDI method in this Letter. It requires only three binarized intensity patterns to illuminate the full field, which can be implemented at ∼22kHz using a digital micromirror device. Each diffraction pattern at the Fourier plane is acquired in a single shot without high-dynamic-range synthesis, resulting in three intensity-only images corrupted with underexposed pixels. We develop an adaptive phase retrieval algorithm to adaptively remove the negative influence of underexposure and recover both the object's amplitude and phase. Both simulations and experiments validate that the method enables fast and high-fidelity complex-field imaging.A tunable light absorption of graphene using topological interface states (TISs) is presented. The monolayer graphene is embedded in the interface of asymmetric topological photonic crystals (ATPCs). A strong absorption phenomenon occurs by the excitation of TISs. It is found that the absorption spectra are intensively dependent on the chemical potential of graphene and the periodic number of the ATPCs. Furthermore, the absorption can be rapidly switched in a slight variation of chemical potential, which is modulated by the applied gate voltage on graphene. This study not only opens up a new approach for enhancing light-monolayer graphene interactions, but also provides for practical applications in high absorption optoelectronic devices. This strong absorption phenomenon is different from those in Fabry-Perot resonators, nano-cavities photonic crystal, and traditional topological photonic crystals (TPCs).Identification of pro-metastatic genomic alterations is urgently needed to help understand and prevent the fatal course of prostate cancer. Here, we found that the transcription factor EGR3, located at chromosome 8p21.3, is a critical metastasis suppressor. Aberrant deletion of EGR3 was found in up to 59.76% (deep deletions, 16.87%; shallow deletions, 42.89%) of prostate cancer patients. In informatics analysis, EGR3 loss was associated with prostate cancer progression and low survival rates. learn more EGR3 expression inversely correlated with the expressions of epithelial-to-mesenchymal transition (EMT) and metastasis-related gene sets in prostate cancer tissues. In prostate cancer cells, EGR3 blocked the EMT process and suppressed cell migration and invasion. In a mouse model for cancer metastasis, EGR3 overexpression significantly suppressed bone metastases of PC3 and 22Rv1 prostate cancer cells. Mechanistically, EGR3 transcriptionally activated ZFP36, GADD45B, and SOCS3 genes by directly binding to their promoter regions.